mode rejection in a sentence

Examples

1. However, the fourth quadrant common-mode response data is a measure of common-mode transmission response and used in a ratio with the differential transmission response to determine the network common-mode rejection.
2. To maximize the common-mode rejection ratio ( CMRR ), differential probes must provide two signal paths that are as nearly identical as possible, matched in overall attenuation, frequency response, and time delay.
3. The magnetic immunity of star quad cable is a function of the accuracy of the star-quad geometry, the accuracy of the impedance balancing, and the common-mode rejection ratio of the balanced receiver.
4. They were designed to have extremely small input current and are still amongst the best op-amps available in terms of common-mode rejection with the ability to correctly deal with hundreds of volts at their inputs.
5. This method starts to fail when the noise source is close to the signal wires; the closer wire will couple with the noise more strongly and the common-mode rejection of the receiver will fail to eliminate it.
6. The common-mode rejection ratio ( CMRR ), usually defined as the ratio between differential-mode gain and common-mode gain, indicates the ability of the amplifier to accurately cancel voltages that are common to both inputs.
7. "' Power mode rejection ratio "'( "'PMRR "') is a term used in electronics and defines how much noise or voltage variations in the power supply will affect the output signal ( s ).
8. ;Common-mode rejection ratio ( CMRR ) : In balanced audio systems, there are equal and opposite signals ( difference-mode ) in inputs, and any interference imposed on both leads will be subtracted, canceling out that interference ( i . e ., the common-mode ).
9. These amplifiers are designed to amplify a very small " sense voltage " of 10 to 100 mV, in the presence of very large common-mode voltages of 5 to 30 V . DC precision ( low input offset voltage ) and high common-mode rejection ratio ( CMRR ) are distinguishing characteristics of these amplifiers.
10. Due to the common-mode rejection of interference characteristic of balanced mains power, a wide range of noise coming from the wall plug is eliminated, e . g . mains-borne interference from air conditioner / furnace / refrigerator motors, switching noise produced by fluorescent lighting and dimmer switches, digital noise from personal computers, and radio frequency signals picked up by the power lines / cords acting as antennae.